Blog2

Why Cpt is so important?

Why Cpt is so important? In the process industry when we calculate the Probability of Failure on Demand (PFDavg) of a Safety Instrumented Function (SIF) we use equations of the following type:   “Cpt” parameter is one of the most important and often is not paid much attention. “Cpt” (Proof Test Coverage) parameter is defined […]

Why Cpt is so important? Read More »

Dangerous failures in the SIS

Dangerous failures of the SIS When calculating Probability of Failure of a Safety Instrumented Function (SIF), the most important are the dangerous failures, as we see in the following equations of 1oo1 and 1oo2 architectures.The value Lambda DD is the rate of dangerous detected failures, and Lambda DU corresponds to the undetected ones. We can

Dangerous failures in the SIS Read More »

The diagnostics in the SIS

The importance of diagnostics in the SIS The diagnostics in an Safety Instrumented System (SIS) are of crucial importance because they are the key to reduce the rates of undetected dangerous failures and, therefore, to reduce the probability of failure on demand (PFD / PFH) and increase the SIL. We can see it in the

The diagnostics in the SIS Read More »

Common cause failures

The importance of common cause failures When designing a control system, we should paid special attention to common cause failures, that is, to the factors that may cause the simultaneous failure of several components or redundant channels. It is an even more important aspect in the case of safety instrumented systems (SIS) and is considered

Common cause failures Read More »

Safety Instrumented Function

What is a Safety Instrumented Function? The safety instrumented function is a control loop in a process or machine whose objective is safety. SIF is its acronym in English. In the following image we see the most common simplified representation of the SIF. The integrity and performance of the safety instrumented function depends on a

Safety Instrumented Function Read More »

SIL requirements

SIL requirements – Systematic Capability, Failure Probability and Architectural Constraints. The designer of the safety instrumented function must verify that the 3 SIL requirements of the IEC61508 Standard are met. Each requirement will meet a certain maximum SIL level. The final SIL of the SIF will be the lowest of the three and must be

SIL requirements Read More »

Isolators and Terminals (phase 7)

Phase 7: Isolators and Terminal Blocks In this article we discuss the options we have for isolators, converters, barriers, terminal blocks and other components (index of design phases). 7-Isolators, field terminals and prefabricated cables Converters, Isolators and Barriers They are used to convert signal ranges, to electrically isolate two circuits, to duplicate signals, to amplify

Isolators and Terminals (phase 7) Read More »

Power Supply (phase 6)

Phase 6: Power Supply and Circuit Breakers In this article we discuss the design of 24 VDC power supply and circuit breakers (index of design phases). 6-Power Supply and Circuit Breakers The design of the power distribution of the control panel is an important aspect that can greatly influence the availability of the plant. Not

Power Supply (phase 6) Read More »

HMI / SCADA (phase 5)

Phase 5: Selection of HMI In this article we discuss the selection of the HMI / SCADA (index of design phases). 5-Selection of HMI or SCADA In medium or large systems, normally the operator interface is defined in the technical specification. If it is a PLC system we will talk about a SCADA, if it

HMI / SCADA (phase 5) Read More »

CPU and Architecture (phase 4)

Phase 4: CPU selection and Control System Architecture In this article we discuss how to select the CPU and describe the main options for the Control System Architecture (index of design phases). 4-CPU selection and design of Control System Architecture The selection of CPU and PLC / PAC model depends directly on several parameters. Some

CPU and Architecture (phase 4) Read More »